How do I reset my Polycom Phone to factory settings?

How do I reset my Polycom Phone to factory settings?

Follow the steps below to factory reset your Polycom phone:

1. Press the Menu or Home button.
2. Select Settings > Advanced. The default admin password is 456.
3. Select Administration Settings.
4. Select Reset to Defaults.
5. Select Reset to Factory.
6. Select Yes to confirm.

How do I factory reset my Polycom VVX 500?

Reboot the Phone—Press and hold 0, 1, and 3 dial pad keys simultaneously until a confirmation tone is heard or for about three seconds. Restore Factory Defaults—Press and hold the 1, 3, and 5 dial pad keys simultaneously during the countdown process in the Updater until the passwordprompt appears.

How do I update my Polycom IP 550 firmware?

Go to “Utilities” >> “Software Upgrade”.

1. Select “Poly Hosted Server” and then click on “Check for Updates”.
2. Go to the Supported Firmwares page, find the firmware version for your device, then select it from the drop-down menu.
3. Click on “Install”.
4. The phone reboots to install the required firmware.

How do I reset my Polycom IP 6000 to factory settings?

To restore phone to factory defaults with the Admin Password:

1. Power cycle the phone.
2. Press Cancel soft key during the boot process.
3. During the countdown, press and hold the following dial pad keys simultaneously until the password prompt appears:
4. Enter the administrator password to initiate the reset.
5. Press OK.

How do I factory reset my VVX 450?

Select Restart Phone (or Reboot softkey on the VVX 450)….To perform a factory reset from the advanced menu:

1. Select Settings from Main Menu, and navigate to Advanced.
2. Enter the phone’s admin password — 456 (see next if you changed and forgot it.)
3. Select Admin Settings.
4. Select Reset to Factory.

How do I factory reset my Polycom vvx201?

Factory Reset

1. Go off-hook.
2. Press and hold the 0, 1, and 3 keys until the phone starts to reboot.
3. Press the Cancel softkey when it appears on the screen (Figure 8-1).
4. Press and hold the 1, 3, and 5 keys until a password prompt appears.
5. Enter the MAC address of the phone as the password.

How do I check my Polycom firmware version?

Checking the Firmware on Poly Phones

1. Reboot the phone (or unplug it and plug it back in).
2. Push Menu.
3. Select Status.
4. Select Platform.
5. Select Application.
6. Select Main.
7. Check the firmware version and determine whether it is 3. X.X or 4. X.X.

How do I reset my Polycom 6000?

Reset Method 1: There are multiple ways you can reset a Polycom IP 6000 conference phone back to factory settings. The first method to reset the phone is while it is booting up. When you see the countdown screen upon booting up the phone, press and hold down 6, 8, and *.

About Bobbi Green

administrator