How do you set the timing on a KA24E?
How to Fix the Timing on a KA24E
- Open and secure the Nissan hood to access the engine.
- Clean the timing degree notches, which are located near the crank shaft pulley.
- Connect the timing light.
- Start the engine, allowing it to warm up.
- Point the timing light at the arrow and timing notches located at the pulley.
Does a 1997 Nissan pickup have a timing belt or chain?
Timing Chains available for the following Nissan Pickup years: 1997, 1996, 1995, 97, 96, 95. This part is also sometimes called Nissan Pickup Timing Chains.
Is the KA24DE a v6?
The KA24DE is a 2.4L inline four-cylinder engine that uses an iron cylinder block with an aluminum cylinder head.
How much is a timing chain repair?
For most cars, a timing chain replacement costs between $413 and $1040, or you can order the parts themselves for $88 and $245. It is a tricky repair though, so unless you’re particularly skilled it’s usually best left to a mechanic.
What is the most powerful Nissan engine?
3500 Horsepower Nissan GT-R: World’s Most Powerful.
How much HP does a KA24E make?
SPEC SHEET
| ENGINE | |
|---|---|
| Peak Horsepower (@ RPM): | 140 bhp @ 5,600 RPM |
| Peak Torque (@ RPM): | 152 lb-ft @ 4,400 RPM |
| Pistons/Compression Ratio: | 9.1:1 |
| Block Material: | Iron |
Is timing chain worth fixing?
Unless there is a specific problem, the timing chain normally needs to be replaced between 80,000 and 120,000 miles. If you drive an older vehicle, or one close to 100,000 miles, you should have it replaced or at least become aware of the symptoms of a failing timing chain.
Can you turbo a KA24E?
Although it is technically possible to run a turbocharger on the stock KA24E or KA24DE injectors, a minimum of 370cc/min is recommended for any turbo setup.
Where are the timing notches on a KA24E?
Rev the engine to 2,000 rpms twice, and then let it idle normally. Point the timing light at the arrow and timing notches located at the pulley. While the engine is running, pull the timing light trigger, and notice where the arrow aligns with the timing notches. Each notch is spaced at 5-degree intervals.
What is the rev limiter on a Nissan KA24E?
The intake valve duration is 240°, valve lift is 10.4 mm (0.409 in); the exhaust valve duration is 248°, valve lift is 10.4 mm (0.409 in). The KA24E rev limiter is set on 6,500 rpm. The Nissan KA24E engine version for SUV uses a camshaft with duration 232°/232°, and valve lift 9.7/9.7 mm. For this engine, redline is lowered to 6,000 rpm.
When did Nissan stop using the KA24E engine?
The KA24E was a workhorse engine in Nissan automobiles from 1988 until 2004. The KA24E came in 2.0- and 2.4-liter versions and was used in many Nissan autos, including: the 240SX, Pathfinder, Stanza and Nissan trucks. As engines run, they sometimes go out of time, causing a rough idle, loss of power and poor gas mileage.
Where does the arrow line up on a KA24E?
The arrow needs to line up with the third notch forward (clockwise) of top-dead center (the center notch). This is 15 degrees before top-dead center, or BTDC. Adjust the timing.
