Are NiteRider lights good?

The NiteRider Lumina Dual 1800 is a top-performing light in pretty much all conditions and its great power and beam spread really took me by surprise. It’s relatively cheap, compared to similar strength lights, and easy to use, ticking plenty of this tester’s boxes.

How do you charge NiteRider Lumina?

Plug one micro USB side of the USB charging cable into the Lumina charging port and the other into your computer. 2. The LED charging indicator on the Lumina will remain red until the battery is fully charged; once charged it will then switch to blue.

How do I unlock NiteRider Lumina?

1. The Lumina headlamp is shipped in lock mode. In order to use the headlamp it must be unlocked. To unlock the headlamp, press and hold the power button for several seconds until the power button turns, or flashes blue.

Are NiteRider lights waterproof?

Are NiteRider systems waterproof? NiteRider systems are water-resistant and will perform in wet weather conditions, but submerging them in water will cause damage.

How do I turn on Niterider 1800?

Simply double tap the power button to set the light to Boost Mode. When in Boost Mode, the power button will illuminate red and blue to notify the user at a glance. The 1800 features side lighting for increased visibility both day and night.

How long do NiteRider Lights last?

The LEDs in our headlamps are not user-replaceable. Replacement should be performed by a NiteRider technician. However, since they are rated for over 50,000 hours of use, it is very unlikely yours will burn out during the life of the light.

How do I turn on Niterider?

In order to use the light it must be unlocked. To unlock the light, press and hold the power button down for approximately 7 to 10 seconds until the power button turn green. Release the button and the press again to turn the light on. For further questions please contact customer support at 1-800-466-8366, ext 4.

Why is my bike light not working?

Diagnosing the problem The first thing you should do is replace the batteries and see if that has any effect. For 1.5 volt batteries you want a voltage somewhere between 1.0 and 1.5. Turn the light on and see if it lights up. Check if the switch is working by measuring the resistance between the two contacts.