Where is the jumper setting on a hard drive?
To find out precisely what the jumper pins do on your hard drive, just search “jumper pins” along with the model number and manufacturer of your drive. You’ll find the relevant support site that tells you which ones to use. Western Digital’s instructions for jumper pin settings on some SATA hard drives.
What is the use jumper setting?
Jumpers are used to configure the settings for computer peripherals, such as the motherboard, hard drives, modems, sound cards, and other components. For example, if your motherboard supported intrusion detection, a jumper can be set to enable or disable this feature.
What is CS enabled on a hard drive?
Cable select, also referred to by the acronym CS, is a disk drive jumper setting which automatically sets the priority of a disk drive by its position on its data cable. When cable select is enabled, the drive configures itself as a primary or secondary depending on its position in the drive chain.
How do I know if my hard drive is connected?
Turn on the system. Check to see if the hard drive is spinning. If you touch the side of the drive you should feel a slight vibration. If you do not hear or feel the hard drive spinning, the drive did not start.
Which disk drives do not require changes to the jumper settings before installation?
Newer Serial ATA, or SATA, hard drives do not require jumper settings for bus configurations.
What is drive cable?
As a critical function within and between devices, data transfer needs cables that are up to the task. Our SATA, USB, FireWire, and other drive cables are built with quality components for speed and reliability.
What is an IDE controller?
This IDE controller, also known as the ATA (Advanced Technology Attachment) controller, is an asynchronous parallel interface between a host microprocessor system and a standard IDE device. Therefore, this can be called a host adapter because it provides a way to connect a complete IDE device to the host.
Which drives are likely to have jumpers you need to set before installation?
Usually, you are most likely to encounter jumpers when installing a new drive, such as a hard drive. As shown in the picture, ATA hard drives have jumpers with three sets of two pins. Moving a jumper between two pins changes the drive from primary drive, secondary drive, or cable select.
What should the jumper settings be on a new Maxtor hard drive?
If your existing drive is set for “Cable Select”, then set your new drive to “Cable Select” also. You can change the existing jumper settings on the original drive to suit your needs, but we recommend following these instructions fi rst to verify proper operation of the new hard drive.
How do I jumper a Seagate Maxtor ATA drive?
If you are connecting the drive to an older system that has a pre-UDMA Mode 3 ATA controller, or you are connecting this to a cable with a slave device that doesn’t have a cable select jumper setting, jumper the drive as Master instead by putting a jumper on the first vertical set of pins closest to the data cable.
How to set jumper block on Maxtor ATA?
If you are unable to match your drive jumper block to one of the styles shown, refer to the jumper settings dia- gram on the drive label. 2. Configure the drive as cable select (CS) by using pliers to move the jumper into the appropriate position on the jumper block.
What should the jumper settings be for Seagate?
Master or single drive. If you are installing your Seagate hard drive as the only drive in the system or if it will be the primary boot drive for the system, the jumper should be set as Cable Select.
