How do I fix the sound on my Onkyo receiver?
Unplug headphones from the receiver when you are trying to use your system with the external speakers. Press the “Muting” button on the remote control to unmute your Onkyo receiver. Check the inputs and outputs to ensure they are correctly connected to the receiver. Adjust the volume controls so you can hear sound.
How do you troubleshoot an Onkyo receiver?
Hold the “VCR/DVD” button while pressing the “On/Standby” button, and the receiver should enter “Standby.” Turn it on again by pressing the “On/Standby” button. Bear in mind that this will clear all the presets and other settings — but it may be those settings that are causing the problems.
How do I test my Onkyo receiver speakers?
To setup your receiver to output the test tone from the speakers, press the Setup button and select Speakers>Manual Setup>Level>Test Tone Star. You can now select and adjust the speakers’ audio level using the “UP, DWN and SIDES arrows” buttons on your remote control.
How do I turn on Onkyo surround sound?
How to Hook Up an Onkyo Surround Sound System
- Plug in the five surround speakers to the back of the surround sound receiver.
- Plug in the subwoofer cable into the “Subwoofer” port on the back of the receiver.
- Place your speakers around the room.
- Connect your devices to the surround sound receiver.
How long do Onkyo receivers last?
Home receivers can theoretically last 30-40 years based on the quality of the hardware. However, due to the rapid advances in home theater technology, the typical lifespan of a home receiver is around 5 years….How long do Onkyo receivers last?
| Receivers | 2 years Parts & Labor |
|---|---|
| Home Theater Systems | 2 years Parts & Labor |
Why does my Onkyo receiver keep turning off?
If the receiver goes into protection with no speakers connected then disconnect all the inputs and other wires and try turning it on again. This isn’t likely to make any difference. If the receiver continues to shut down then it has an internal problem that would require a technician. Hope it’s under warranty.
Is there a reset button on Onkyo receiver?
Hold down the “VCR/DVD” button and, with another finger, press the “On/Standby” button. Watch the display. You should see “Clear” appear on the receiver’s display before it goes into standby mode.
