How does a Torbeck diaphragm washer work?
The basic principle is that water pressure bears on both sides of the rubber diaphragm but there’s more surface area exposed to the water on the side that presses the diaphragm against the inlet shutting off the water flow.
Which way round does a diaphragm washer go?
Normally the washer is fitted with the convex side facing the arm and float. The assembly at the other side of the valve body is valve cone facing inwards (pointy end in first) then washer (rubber should be ok) then rear body section.
How do you adjust a Siamp inlet valve?
Adjust water level with the grey adjustable screw ; screw to increase water level, unscrew to decrease it. Adjust the float box to the float level and turn the small white screw to close the box, while pressing on the grey screw. SIAMP UK will be not responsible in case these warnings are not respected.
Which way round fits a diaphragm washer?
Is there a bottom entry float valve for Torbeck?
Mouse over image for a closer look. Torbeck Cistern Bottom Entry Float Valve added to “My Project List”. You are not logged in to save your list permanently. Until you log in, your list will be saved temporarily and can only be accessed from the device you are using now. Next day delivery.
Why is my Torbeck toilet valve not working?
Could it be that the adjusting stem on the float is touching the cistern lid, so not allowing the valve to shut off. To check this try leaving the top off and see if the problem disappears. If so then trim down the adjusting stem slightly. THANK YOU Leakey Leonard!!!!
Can a strainer be fitted for a Torbeck valve?
Turn your water supply off clean the valve and allow the system to flush through. You will have to collect the water so as not to make a mess. It may be possible to fit a strainer to prevent debris entering the valve mechanism. I can answer this question…
Is the Torbeck valve for cisterns good or bad?
Since starting to fit Torbeck valves a few years ago, we’ve had endless grief with noisey cisterns and valves which won’t shut off, wasted water and loads of expensive callouts for plumbers. In my opinion, Torbeck valves are rubbish. I will never have another fitted.
