Is ToolKraft still in business?
Address (1949 Popular Mechanics): Waterbury 91, Connecticut. ToolKraft remained in business until the 2010s; for the couple of years they were not making new machines but were providing parts and service. By 2020 their website was no longer working.
What is a Delta jointer used for?
The 6″ Jointer by Delta Machinery will perform clean, precise cuts every time. A heavy duty cast iron fence provides accurate jointing. With a precision-machined table and fence you’ll get to experience long lasting accuracy. Cut up to a maximum width of 6″ and enjoy up to 1/8″ depth of cut.
Do you need a large jointer?
Ideally, you should get a jointer that’s large enough that you rarely need to split wood before milling. Bigger isn’t always better.
What is the purpose of a jointer?
A jointer is used to make the face of a warped, twisted, or bowed board flat. After your boards are flat, then the jointer can be used to straighten and square edges (guard removed for photo).
What is a good size jointer?
An 8-inch wide jointer allows me to joint wider boards than a 6-inch jointer, and 8-inch jointers usually come with longer infeed and outfeed beds, adding more support to the lumber. And 8-inch jointers are usually affordable enough for hobbyist woodworking shops.
Is a 6 jointer enough?
A 6″ jointer will certainly get you by, so I don’t want you thinking an 8″ jointer is a requirement for high quality work. I know many people who get along quite nicely with small benchtop jointers and even some crazy individuals who would rather use their #7 jointer plane to get the job done!
Can I use a table saw instead of a jointer?
Using Your Table Saw as a Jointer. Even if you own a jointer, you’ll want to master this technique. With the addition of a simple shop-made fence, you can easily edge joint on your table saw.
What is the difference between a jointer and a planner?
A jointer creates a flat surface on wood, and yes, it can be used to correct bow and warp on one side of a board at a time. “A planer is a thicknesser. In other words, you put a board into the planer to make it thinner after you have already established one flat side using the jointer (or a hand plane.)
Can you use a jointer on both sides?
No, you cannot. This will make the board square, but it will NOT ensure it doesn’t taper. With the jointer you can only make each corner square. You can’t make the opposing faces parallel with each other.
What is the maximum depth of a cut on a jointer?
The maximum depth of cut is 1/16”; never force, or over feed the jointer by taking too thick of a cut. Final passes should be no more than 1/32”.
Where did the company toolkraft get its name?
According to the trademark filing, the ToolKraft name was first used in 1948. The Massachusetts corporate registry database lists ToolKraft Corp.’s first registration as 1956-09-27. A 1948 issue of School Shop lists “Toolkraft Corp. 449 Meadow St. PO Box 431 Waterbury 86, Conn.”
When did Darra James change their name to toolkraft?
By January 1948 the company name had changed to ToolKraft Corp. ToolKraft made home-shop machines that were sold under a variety of labels, including ToolKraft, Darra James, Powr-Kraft ( Montgomery Ward ), DeWalt (jointer, shaper), Duramark (T. Eaton Co.) and others; look for model numbers with the prefix “THS”.
When was the first toolkraft table saw made?
The ads show a 7″ tilting-table saw and a combination disk and drum sander. According to the trademark filing, the ToolKraft name was first used in 1948. The Massachusetts corporate registry database lists ToolKraft Corp.’s first registration as 1956-09-27.
