What would cause a chainsaw not to start?

The chainsaw’s engine is flooded with fuel. A fuel issue is one of the most common reasons why a chainsaw won’t start. If you believe fuel has flooded the chainsaw engine, pull the starter cord several times while holding the throttle, dry and replace the spark plug, and then try starting the chainsaw again.

What is bar and chain lubricant?

Bar and Chain Lube is a para-synthetic, tacky, heavy-duty oil designed to lubricate chain saw bar and chains, slides and saw guides. Bar and Chain Lube is one-grade lube for year-round use, eliminating the need to change viscosity grade with temperature change.

Why is my electric chainsaw not cutting?

The most common cause of a chainsaw that won’t cut properly is a dull cutting chain. Try sharpening or replacing the chain. If the chain is too tight, the chain may not rotate at the proper speed, causing the chain not to cut properly. To adjust the chain, tighten or loosen the adjustment screw.

Why has my electric chainsaw stopped working?

If your electric chainsaw won’t start, try examining it for these issues: Tripped electrical breaker (for corded chainsaws) Frayed or damaged electrical cord (for corded chainsaws) Bad or undercharged battery (for cordless chainsaws)

What do you do if your Stihl chainsaw won’t start?

Dirty or clogged fuel tanks, dirty fuel filters and lines, loose fuel hoses, dirty air filters and a dirty carburetor can all restrict fuel flow. Check, clean and replace all the fuel system parts before moving into the internal engine, as gas problems create a majority of starting problems.

How do you adjust the fuel mixture on a chainsaw?

Carburetor Adjustment Procedure

Before you start the saw, locate a small flat-bladed screwdriver.
Begin by checking the saw’s air filter.
Check the fuel level.
Start the engine and warm it up.
Begin by setting the idle speed.
Set the low speed fuel adjustment.
Go back to step (4) and reset the idle speed.

How do you adjust a carburetor on a craftsman?

How to Adjust a Carburetor in a Craftsman

Locate the carburetor on your Craftsman equipment.
Turn the main mixture and idle mixture screws on the carburetor counterclockwise about one full turn with a flat-head screwdriver.
Start the engine with the transmission in neutral and let it run for several minutes.