What setting should I set my water softener on?
Once you understand exactly what the hardness level is, you will want to set the softener in accordance with the level. For instance, if your hardness is running at a 25, you would set it to 25 on the unit. Most of the time this is done by turning a dial or programming an electric head unit.
What do the settings on a water softener mean?
Water softeners have four basic settings — regeneration cycle frequency, regeneration cycle time, regeneration cycle length and salt dose. Most of the settings revolve around the regeneration process, which is a critical stage in the water softening process.
How do I set the dial on my water softener?
To put this information into a day clock softener, just set the salt setting (see below), then divide your daily consumption, in grains, into the total grain capacity of your softener, then set up the time clock so that it will regenerate when the capacity is exhausted.
What percentage should a water softener be set at?
Your water softener hardness setting should be set to the amount of hardness in your water plus 4 for every part per million of dissolved iron in your water. On an older water softener, you may need to set your hardness slightly higher as the resin becomes less efficient.
Why is my water softener brine tank full of water?
Debris may enter the brine tank and get sucked up through the valve. One of the most common causes of too much water in the brine tank is an injector obstruction. The injector has a very small hole that creates suction or venturi to draw the brine. If that hole becomes clogged it will need to be removed and cleaned.
How much water should be in my brine tank?
Wet Brine Tanks: That works out to about 15-25 cm (6-10 inches) of water. The water will be in your tank even in between regeneration times or cycles. You may not see the water if your salt level is higher than your water level.
How do you set the time on a water softener?
If you have an older water softener, you will need to pull the dial slightly out before turning the hour and minutes dials to set the current time. Determine what time your household doesn’t use any water.
How do I set my water softener to automatically recharge?
Find the button or tuner on your water softener that indicates the day of the week, and turn the dial or press the button to the day you wish to recharge your water softener. Automatic rechargers can determine when to recharge without a manual setting. Read owner’s manual thoroughly before setting controls
Why is it important to set controls on water softener?
Setting the controls on your water softener is important because it allows you to set the clock to your family’s preferences. Additionally, a water softener helps remove mineral and chemical build-ups that cause hardened water.
How to set a water softener to regenerate?
If the test shows results in parts per million (PPM), divide the PPM value by 17.1 to determine the grains per gallon (GPG). Set your water softener’s hardness dial (sometimes referred to as a brine control) to match the GPG figure determined by the water test. Pull out the timer knob and set the current time on the water softener’s timer dial.
