How do I find RAID configuration on Dell R710?

On first boot, you use the PERC 5/I Configuration utility to configure the RAID controller:

Select the controller, select Disk Group 0, then press F2.
Select Add New VD.
Select the RAID Level value, press Enter, select RAID 5 from the list, then press Enter again.
Under Basic Settings, fill in the following fields:

How do I raid a Dell server?

Press to enter Configuration Utility…

Enter System Setup or BIOS by tapping the F2 key at the Dell splash screen.
Go to the System Configuration.
Select the SATA Operation Mode.
Change the mode to RAID On if it was not already set and apply.

How do I know if my Dell server has a RAID?

How to Guide: Checking if a RAID is configured

Rick click on the “computer” icon on the desktop.
Select Manage.
Expand Storage.
Click Disk Management.
In the bottom center pane you’ll see different Disk numbers.
Under the Disk number you’ll see either Basic or Dynamic.

How do I setup raid on my Dell computer?

Enter System Setup or BIOS by tapping the key at the Dell splash screen. Navigate to the category that contains the SATA Operation mode. Select the SATA Operation Mode. Change the mode to “RAID On” and apply or click yes.

How do you tell what raid a server is using?

5 Answers

Rick click on the “computer” icon on the desktop or the computer item in the Start Menu.
Select Manage.
Expand Storage.
Click on Disk Management.
In the bottom center pane you’ll see Disk 0, Disk 1, etc.
On the left column under the Disk number you’ll see the word Basic or Dynamic.

What is RAID configuration?

A Random Array of Independent Disks (RAID) is a set of multiple drives put together with the purpose of improving a single drives performance. Some RAID configurations provide a speed boost while others provide data protection in the event of failed drives. Some RAIDs can provide both.

How do I access Dell BIOS RAID?

How do I setup a Dell server?

Setting Up Dell EMC PowerEdge Server Using Lifecycle Controller

Open Lifecycle Controller. Power on the server and press F10 to open Lifecycle Controller.
Set up Lifecycle Controller.
Verify the applied network settings, and click Finish to exit the Initial Setup Wizard.
Update the firmware.

Why is my power edge R710 RAID controller not working?

I have a R710 with PERC H700 which suffered a power module failure and shutdown unexpectedly. I replaced the power module and when I boot up, I see a E1211 battery failure for the RAID controller and it is not detecting the virtual disk created as RAID1 using drives from Bay 0 and 1.

Is the Dell PowerEdge R710 a rack server?

The Dell PowerEdge R710, with the performance of Intel Xeon processors, offers you a 2U rack server to efficiently address a wide range of key business applications. Dell PowerEdge R710 Technical Guidebook ii

How to replace faulty HDD in PowerEdge R710?

RE: Procedure to replace faulty HDD with New HDD in poweredge R710 conf. with RAID 10. You can offline the drive in the CTRL-R utility… boot to CTRL-R, PD MGMT screen, highlight the predictive failure drive, F2, offline. THEN insert your replacement drive. 0 Kudos

What kind of RAID controller do I Need?

Am using Dell PowerEdge PERC H700 6Gb/s 512MB SAS RAID Controller R374M XXFVX in this box. I have 6 bays filled with the same type of 4 tb disks. Bay 0 and 1 were used for creating a mirrored (RAID 1) virtual disk. the remaining 4 disks are used to create the virtual disk 1.