What is R2 zoning in Tacoma?
R-2: Single-Family Dwelling District It permits all uses allowed in the R-1 and may also allow for lodging uses limited to one guest room. It generally abuts more intense residential and commercial districts. The minimum standard lot size in the R-2 District is 5,000 sq. feet; small lots may be 4,500 sq.
What is zoned R2?
R2 is a zone for land comprised mainly of low density housing where the planning objective is to protect the locality’s single dwelling character and landscape setting. The zone also allows for a variety of housing types, facilities and services to meet the needs of the community and residents.
How tall can a fence be in Tacoma WA?
seven feet
Fences can be built up to seven feet in height without a permit, provided the fence is structurally sound, is located entirely upon private property, and does not block the view from vehicular traffic entering into or turning onto the street (see graphic on page 2 of this tip sheet).
How is side yard setback measured?
The side setback shall be measured from the point on the side property line of the parcel nearest to the structure, establishing a setback line parallel to the side property line, that extends between the front and rear yards.
What is considered a small lot?
The definition of “small lot” can vary considerably from market to market (2,500 square feet in Southern California; 5,000 square feet in Raleigh, N.C.). As opportunities for small-lot detached housing develop in infill locations, some municipalities are revising their building codes to streamline the approval process.
Do I need a permit Tacoma?
A. Yes, to do work in the City of Tacoma both a City business license and Washington State contractor’s license are required. For information on obtaining a Washington State Contractor’s License contact the State of Washington Contractor’s License division 1-800-647-0982.
Do I need a permit to build a deck in Tacoma?
A deck that meets the following requirements is exempt from a building permit: Deck must be 200 square feet or less. Deck must be 30 inches or less above grade at any point. Deck is not attached to the house, and does not serve as a required exit door.
What are the zoning regulations for Tacoma WA?
Tacoma Municipal Code (TMC) 13.05.010.B – Variances, 13.06.020 – Residential Districts, 13.06.020.K & 13.06.100.F – Small-Lot Single-Family Development District, 2.02 – Building Code TacomaPermits.org
How long does it take to change the Tacoma Municipal Code?
Unless specifically addressed in the ordinance, changes to the Tacoma Municipal Code (TMC) are effective ten days after the ordinance has been published in the City’s official newspaper (publishing typically takes place two days after an ordinance is passed).
What are the residential districts in Tacoma WA?
The specific purpose of the residential districts can be found in the Tacoma Municipal Code Section 13.06.100. R-1: Single-Family Dwelling District The R-1 District is intended for a typical -family residential single neighborhood. It is most appropriate in established areas with a relatively quiet and stable neighborhood environment.
Who is the building official in Tacoma WA?
“Building Official” shall mean the individual authorized by the Director of the Planning and Development Services Department of the City of Tacoma, charged with the administration and enforcement of the Building Code, or a duly authorized representatives.
