Where is the blower motor relay located?
The blower relay is located near the front of the fuse block and is labeled “Blower.” Inspect the center of the relay. If the metal rod inside is broken, the relay will need to be replaced.
Where is the blower motor relay on a 96 Jeep Cherokee?
The blower motor relay is located in the fuse and relay center under the hood to answer your question, but think the White connector under the glove box (remove any lower dash panel that is there) will be the problem, wiggle it and see if the blower starts.
Where is the blower motor fuse relay?
Under the instrument panel, look under the glove box. On the right side of the fender wall you will find another fuse box.
How do I know if my blower relay is bad?
If you have a faulty blower motor, you may experience low airflow from the vents, even when the fan is on high. There will be no air coming from the vents if your fan isn’t working due to a bad blower motor resistor.
What happens when a blower motor relay goes bad?
If the blower motor relay develops any sort of problem that hinders its ability to properly limit and distribute power, it may cause the blower motor fuse to blow. Any sort of electrical spikes or excessive current from a bad relay will blow the fuse and cut power in order to protect the system.
What happens if your blower motor relay goes bad?
How do you test a blower relay?
Connect a test light or multimeter to the ground (black lead). Turn the ignition key to the on position (engine off), and remove the relay. Using the probe, test all terminal sockets in the relay connector. Two of the four should have power.
What are the symptoms of a bad blower motor?
Here are just a few of the signs that your blower motor is going bad.
- Weak airflow. This is one of the first signs of a bad blower motor that people tend to notice.
- Noises. Have you noticed any unusual noises coming from your vehicle’s HVAC system?
- Smoke or smells.
What does a bad blower resistor look like?
The most common symptom of a failed blower motor resistor is when the heater fan only runs at the highest speed setting (4 or 5) and doesn’t work at low speeds. In some cars, a failed blower motor resistor can cause a heater fan to stop working completely.
How much does it cost to replace a blower motor resistor?
The average cost for blower motor resistor replacement is between $108 and $137. Labor costs are estimated between $44 and $55 while parts are priced between $64 and $82. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
Where is the blower Motot relay on a 1998 Jeep Gran Cherokee?
Where is the blower motot… Where is the blower motot relay on a 1998 Jeep Gran Cherokee Submitted:12 years ago. Category: Jeep Show More Show Less Ask Your Own Jeep Question Share this conversation Answered in 6 minutes by: 11/26/2008 Jeep Mechanic: Jerry, Master Mechanic replied 12 years ago Jerry, Master Mechanic Category: Jeep
What does a fuse on a Jeep Cherokee do?
Fuse box diagram (fuse layout), location, and assignment of fuses and relays Jeep Cherokee XJ (1984, 1985, 1986, 1987, 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996). A fuse is an element for protecting the electrical system. A fuse will trip (i.e. it will blow) in the event of a failure or improper interventions in the electrical system.
Where is the Horn relay located on a 95 Jeep Grand?
On my 95 Jeep Cherokee Laredo, the horn relay is in a compartment under the glove box. Open the glove box and remove the three screws in the front on the bottom. Take the plastic cover out and you’ll see a bank of relays. The horn relay is the one on the far left, closest to you.
What is the ignition switch on a Jeep Cherokee?
Ignition Switch – Back-up Lamps, A/C Relay Coil, Shift Selector, Speed Control, Aux. Cooling Fan Relay Coil WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.
